Clean Seal System Procedures
Our advanced capping method uses heat to shrink capsules onto cleaned hose and tube assemblies
Slide the correct size Clean Seal Capsule over the end fitting.
Place the Clean Seal Capsule against the white plunger and push in.
A complete seal takes place in less than two seconds.
Multiple hose ends can be sealed cleanly and quickly depending on their size.
The Clean Seal Capsule will not generate contamination during the installation or removal process and it stays on until you’re assembly is ready for use.
The clean seal capsule has a unique tear strip that is easy to grab with or without gloves.
Pull the tear strip up to remove the capsule cleanly from the hose end.
For more questions about the Clean Seal System or any other Ultra Clean Product, please call or email one of our product specialists today.
Sizing the correct Clean Seal Capsule for your application is easy. Measure the end fitting from point to point on a hex style nut or the largest outside diameter of the end fitting. Sizing charts can be found in both nominal inch and millimeter in our Product Manual and Clean Seal System brochure. They are also available on our website www.ultracleantech.com. The correct Clean Seal Capsule part number will be displayed in both Bulk and Pre-Packaged quantities.
Clean Seal Capsule Application is both fast and easy. Turn the switch to the ON position and the Green light will illuminate.
Turn the 60-minute timer to the appropriate minute interval. The heat will come on and a white light will illuminate. The machine will need a few minutes to reach the correct temperature from a cold start.